Edesa 4 SE Notice D'utilisation page 41

GB
O O P P E E R R A A T T I I O O N N
To open the door, grip the handle and pull outwards.
Before running the drying cycle:
- Check that the plug is in the power outlet.
- Check that the filter is in place.
- Put the spun laundry in the drum without compacting it.
- Check that pets or other foreign bodies haven't got into the drum by mistake.
- Close the door.
At this point you can select the drying programme you want, as follows:
- turn PROGRAMME SWITCH (1) clockwise to the desired drying programme;
- press DELICATES button (6) if you have to add delicate and/or 100% synthetic
items;
- press START button (2) to start the machine.
IMPORTANT: if you open the door during a drying cycle, you must press start
button (2) again to restart the machine.
The drying cycle starts and the power led lights up.
At the end of the selected time, an air cooling cycle starts.
This allows laundry to cool down gradually.
In models with an anti-crease programme, the cooling cycle is followed by a 30
minute anti-crease phase.
In this phase the drum turns intermittently.
The laundry is kept in continual motion and softened by air to prevent creasing.
At the end of the cycle the programme switch stops on the STOP position. Remove
your laundry and turn the drum to check no small items have been left behind.
You may also take out your laundry at the end of the cooling phase. If you see that
certain items haven't dried sufficiently, put them back in the dryer and set an extra
drying time.
Clean the filter after each drying cycle.
- 41 -