Reversing The Door - Edesa 4 SE Notice D'utilisation

TIPS
•
To get the best out of the dryer, don't install it in a room where the ambient
temperature is under 10° C.
•
Before using the dryer for the first time, clean the inside of the drum with a damp cloth
to remove any dust which may have accumulated during transport.
CAUTION
•
The dryer must under no circumstance be connected to a chimney flue.
•
There must be no lint around the dryer, as it could be sucked into the appliance.

REVERSING THE DOOR

If you need to reverse the door, follow these
instructions:
1. On the front panel, unscrew the 4 screws (1)
supporting the hinges (2) of the door (3).
2. Invert the position of the micro-switch (5) from (a)
to (b).
3. Invert the position of the plugs covering the door
mounting.
4. Mount the door using the holes left open.
E E L L E E C C T T R R I I C C A A L L C C O O N N N N E E C C T T I I O O N N
Before plugging the dryer into a power outlet make sure that:
1. the value of your mains voltage is the same as the value indicated on the rating plate
on the front of the machine;
2. the counter, limiter valve, supply line and power outlet are all to standard and
suitably sized to resist the maximum load required; the power and input current
values are given on the rating plate;
3. the power outlet and plug are compatible without using reductions, multiple sockets,
adapters or extensions.
It is a legal requirement that the appliance be connected to an earth system.
If the power line is damaged, it must be replaced with a special cable or kit
available from the manufacturer or customer service.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR DAMAGE
CAUSED TO PERSONS OR PROPERTY THROUGH NON OBSERVANCE OF
THESE BASIC SAFETY REGULATIONS.
3 5(a)
2
(b)
- 37 -
1
1
5(b)
GB