La Sommeliere MZ135DZ Manuel D'instructions page 32

NOTE: All parts removed must be saved to allow the door swing to be reversed
1. 1.Use the sharp tools to pry open the decoration nail on the top of the cabinet and the cap of
door spindle carefully. (Fig 1)
2. Open the door to an angle, unscrew the screw of the door hinges cover, remove the cover of
the upper door hinge; then unscrew all the screws on the upper door hinge. Be careful to hold
the glass door firmly after removing the screw and take off the door. (Fig 2)
3. Remove the screw of lower door hinge and the left side screw of the front vent (Fig 3); and
then install the lower door hinge at the designated position on the opposite side (Fig 4).
4. Remove the screw of door handle, then remove the bottom screw of left side of the door and
remove the lower supporter of the door. (Fig 5); Install the lower support of the door to the
opposite side. (Fig 6).
5. Pull open middle section of the door gasket, then it will come out the handle screw hole. (Fig
7); remove the handle and install it on the opposite side. (Fig 8)
6. Install the upper door hinge to the opposite side and tighten the screws. (Fig 9)
7. Set glass door shaft to aim the shaft of lower door hinge (Fig 10); and then aim the upper
door hinge (Fig 11); adjust the door and the cabinet is aligned and leveled, then tighten all the
lock screws.
You also can call customer service for reversal instructions if it is necessary.
Door Lock
Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the User's Guide. Insert the key into the lock
and turn it counterclockwise to unlock the door. To lock the door, do the reverse operation making
sure metal pin is engaged completely. Remove the key and place it in a secure place for safekeeping.
Temperature alarm
If the temperature is abnormally high, the display will show the error code "HH", if the temperature is
abnormally low the display will show the code "LL".
32