Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 1 fixing bracket
- 1 BHc 6×15 screw
- 1 Ø6 plastic washer
Assembly
- Cut the small suspension's protection (see photo).
- Remove the chain protection and keep the original screws.
- Place the bracket on the right hand-side of the swinging arm, for that, insert the flat part into the
ring which hold in position the brake hose. Assemble the second part of the bracket.
- Mount the rear fender on the swinging arm by placing every screw without tightening them.
- Centre the rear fender and block the screws' tightening.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
* The rear hugger and undertray are compatible.
Original tyre Bridgestone Battlax BT 020 160/60 ZR17
"ATTENTION"
FITTING INSTRUCTIONS
« REAR HUGGER »
600 BANDIT 2000/2004
650 BANDIT 2005/2008
GSXF 650 2008 → ∞
Publicité
