Endress+Hauser NAR300 Manuel De Mise En Service page 9

Système de détection de fuite d' h uile NAR300 pour haute température
Endress+Hauser
Order code
Ser. no.
F M
APPROVED
Intrinsically safe circuit:
Non Intrinsically safe circuit:
Power supply
Um : AC 250 V 50/60 Hz, DC 250 V
Contact output : 5 A 250 V AC, 5 A 30 V DC
Manufacturing date:
Conduit entry of the main body: M26 x 1.5
Caution
WARNING: AFTER DE-ENERGIZING, DELAY 10 MINUTES BEFORE OPENING.
Endress+Hauser Yamanashi Co.,Ltd.
Yamanashi 406-0846
Figure 9 : NRR261 pour FM (type séparé NAR300)
1. Référence de commande
2. Numéro de série
3. Alimentation
4. Date de fabrication
Order code
Ser. no.
Non Intrinsically safe circuit:
Power supply
Um : AC 250 V 50/60 Hz, DC 250 V
Contact output : 5 A 250 V AC, 5 A 30 V DC
Manufacturing date:
Conduit entry of the main body: M26 x 1.5
Caution
WARNING: AFTER DE-ENERGIZING, DELAY 10 MINUTES BEFORE OPENING.
Endress+Hauser Yamanashi Co.,Ltd.
Yamanashi 406-0846
Figure 10 : NRR261 pour ATEX et IECEx (type NAR300 intégré)
1. Référence de commande
2. Numéro de série
3. Alimentation
4. Date de fabrication
XP-AIS Class I, Div. 1,2, Gp. C, D, T6
Class I, Zone 1[1], AEx d[ia] IIB T6
Ambient temperature: -20
3
4
: A seal shall be installed within 18 inches of the enclosure.
: Do not modify internal parts or circuits.
: Use supply wires suitable 70 minimum.
: Do not open the cover when energized.
: Refer to control drawing Ex1088-1192- .
Made in Japan
ATEX: II 1/2G Ex d ia[ia Ga] IIB T4 Gb
FM 14ATEX0048X
IECEx: Ex d ia [ia Ga] IIB T4 Gb
IECEx FMG 14.0024X
Ambient temperature: -20
3
4
: Do not modify internal parts or circuits.
: Use supply wires suitable 70 minimum.
: Do not open the cover when energized.
: Refer to Ex-instruction manual XA01103G- /08/EN.
Made in Japan
NRR261
1
2
+60
NEMA 4X, IP67
NP - 2671
NRR261
1
2
NEMA 4X, IP67
+60
NP - 2676
Identification
9