Warranty - Liberty Pumps SumpJet SJ10 Manuel D'installation

7. Turn the municipal water supply back on and open the
shut-off valve. Check for leaks. Test the SumpJet to ensure
that it is operational by filling the sump pit with water from a
garden hose or bucket.
8. Re-connect primary electric sump pump to power supply.
9. If sump cover is desired, it will be necessary to add additional
holes and slots to make access for the SumpJet suction pipe
and float rod. Refer to the template provided in Figure 4.
10. If the SumpJet cannot be mounted to the primary sump
pump discharge pipe, a piece of wood may be used to mount
the SumpJet. Cut holes as per Figure 4. There are four screw
holes to fasten the SumpJet to the wood. Use #8 x 2.5" long
wood screws. Refer to Figure 3.
Figure 3. Alternate SumpJet Installation
– 6 –

Warranty

Liberty Pumps Wholesale Products Limited Warranty
Liberty Pumps, Inc. warrants that Liberty Pumps wholesale
products are free from all factory defects in material and
workmanship for a period of three (3) years from the date of
purchase (excluding batteries). The date of purchase shall be
determined by a dated sales receipt noting the model and serial
number of the pump. The dated sales receipt must accompany the
returned pump if the date of return is more than three years from
the date of manufacture noted on the pump nameplate.
The manufacturer's sole obligation under this Warranty shall be
limited to the repair or replacement of any parts found by the
manufacturer to be defective, provided the part or assembly is
returned freight prepaid to the manufacturer or its authorized
service center, and provided that none of the following
warranty-voiding characteristics are evident:
The manufacturer shall not be liable under this Warranty if the
product has not been properly installed, operated, or maintained
per manufacturer instructions; if it has been disassembled,
WOOD 2x4
modified, abused, or tampered with; if the electrical cord has been
cut, damaged, or spliced; if the pump discharge has been reduced
in size; if the pump has been used in water temperatures above
the advertised rating; if the pump has been used in water
containing sand, lime, cement, gravel, or other abrasives; if the
WOOD SCREWS
product has been used to pump chemicals, grease, or
#8x2.5" long
hydrocarbons; if a non-submersible motor has been subjected to
moisture; or if the label bearing the model and serial number has
been removed.
Liberty Pumps, Inc. shall not be liable for any loss, damage, or
expenses resulting from installation or use of its products, or for
indirect, incidental, and consequential damages, including costs of
removal, reinstallation or transportation.
There is no other express warranty. All implied warranties,
including those of merchantability and fitness for a particular
purpose, are limited to three years from the date of purchase.
This Warranty contains the exclusive remedy of the purchaser,
and, where permitted, liability for consequential or incidental
damages under any and all warranties are excluded.
Copyright © Liberty Pumps, Inc. 2018 All rights reserved. 5824000H