Specifications; Troubleshooting - Anker Nebula Capsule Max Mode D'emploi

EN

Specifications

Specifications and design are subject to change without
notice.
Power supply: DC 15V 3A
Power consumption: < 20W
Standby power consumption: < 0.5W
Display technology: 0.3 in 1280 × 720p DLP
Light source: RGB LED
Projection image size: 20-100 in
Resolution: 1280 × 720p
Brightness: 200 ANSI Lumens
Contrast ratio: 600:1
Throw ratio: 1.3
Throw distance: 0.58 m to 3.08 m
CPU: Quad core A53
OS: Android 8.1
RAM: 2GB DDR
ROM: 16GB eMMC
Speaker drivers: 8W
Wi-Fi: IEEE802.11b/g/n/ac Dual Frequency 2.4G / 5G
Bluetooth version: 4.2
USB file system: FAT32 / NTFS / exFAT
Built-in battery type: Li-Polymer
Capacity: 9,700mAh 3.7V
Movie playtime: approximately 4 hours in battery mode (local video)
Recommended ambient: 41°F to 95°F / 5°C to 35°C
Relative humidity: 15% ~ 85% (non-condensing)
Storage temperature and humidity: < 149°F / 65°C, < 90% humidity
Dimensions (H × D): 150 × 80 mm / 5.9 × 3.1 in
Weight: 737 g / 26.0 oz
21

Troubleshooting

① Fail to power on by the remote control?
• Press and hold for 2 to 3 seconds on the projector to turn it on.
• When powered off, you cannot use the remote control to turn it on.
② The remote control doesn't work?
• Make sure you remove the plastic battery insulation tab.
• Make sure the battery is already installed in the remote control.
• Replace the batteries.
③ Blurred image?
• Slightly move the projector to engage autofocus.
④ Cannot connect to a Wi-Fi network?
• Refresh the list of available networks and retry.
• Reboot the wireless router or the device and retry.
⑤ How do I update the firmware?
• When a new version is detected you will be asked to reboot and
update.
EN
22