Samsung RT18M Serie Guide D'utilisation page 26

Installation
To install the ice maker kit
WARNING
To prevent electrical shock, make sure the refrigerator is turned off before installation.
English
26
Untitled-6 26
1. See the figure on the left, and then
locate the cover on the inner upper
corner of the main unit.
2. Remove the screws (x2) from the cover,
and then remove the cover by pulling it
to the front.
3. Connect the wire connector of the ice
maker to the socket (marked in the
figure) on the main unit. Make sure the
connector is fully inserted to prevent
system failure.
4. Insert the ice maker into the front side
of the 2 grommets as shown. Then, push
the ice maker inwards to the end. To
prevent deviation of the ice maker, make
sure the ice maker fits into position.
2020-11-11 PM 2:43:44