Tinyloc R2 FINDER Manuel D'instructions page 68

1. "SEARCH"
This option will take you straight to the search screen for the selected collar in radio tracking
mode.
MENU>COLLARS>SAVED COLLAR>SEARCH, press the "OK" key
2. "ON"
This option lets you turn the collar on from a distance of up to 5 meters from the R2 Finder without
using the magnet.
In the R2 screen you will be prompted to choose between turning the collar on in "NORMAL"
mode or turning the collar on in "DOGSTAT" mode.
MENU>COLLARS>SAVED COLLAR>TURN ON > NORMAL/DOGSTAT and press the "OK" key
- The NORMAL mode allows you to perform conventional searches.
- The DOGSTAT mode is intended to provide additional information after the search. The
DOGSTAT mode records all GPS positions into the collar memory. At the end of the hunting
day, you will be able to reproduce the route followed by the dog, the maximum and minimum
speed and even the calories the dog has burned.
To obtain these statistics, you must download the exclusive DOGSTAT software free of charge
from www.tinyloc.com and acquire the DOGSTAT cable (not included in the R2 Finder).
3. "OFF"
This option lets you turn the collar off from a distance of up to 5 meters from the R2 Finder without
using the magnet.
MENU>COLLARS>SAVED COLLAR>TURN OFF, press the "OK" key.
4. "SETUP"
This option lets you change the collar channel to avoid interferences. The channel configuration
supported by the R2 Finder goes from 00 to 99. Although four zeros (0000) will appear, you
should always select only two digits.
Interference may occur if there are two collars with the same assigned channel or very close
channels in the same area. To solve the problem it is advisable to change the channel, go to:
MENU>COLLARS>SAVED COLLAR>SETUP>CHANGE CHANNEL>CURRENT CHANNEL 3,
NEW?>SELECT NEW CHANNEL>END, press the "OK" key
64