Tinyloc R2 FINDER Manuel D'instructions page 66

c) BY FREQUENCY
Transmitters functioning only with radio tracking technology (Minihound, F22, MU or HU) must
always be entered manually into the R2 Finder by using the "ADD FREQUENCY" option.
HOW TO ADD A COLLAR::
To enter a collar by frequency, follow these steps:
MENU>ADD>ADD FREQUENCY and press the "OK" key.
1- The display will show a line with numbers 0 to 9. Select each of the numbers in the collar
frequency and press "OK" to confirm.
2- When entering a collar by means of the "FREQUENCY" option, the R2 Finder will ask you to
perform automatic calibration. (The process with which the receiver best adjusts the transmit-
ter frequency).
3- To perform the automatic calibration, the collar must be physically available. If you do not
have the collars at this time, when asked "DO YOU WISH TO CALIBRATE?", select the "NO
CALIBRATION" option and press "OK ".
NOTE: The first two digits of the frequency are already entered by default, you will only need to
enter the remaining four.
Example: Your collar frequency is: 433.250 MHz,
The display will show 43 _ . _ _ _ MHz.
Therefore, you should enter 3250 to get the full frequency,
Figure 8
433.250 MHz
62