Kobalt SGY-AIR145 Mode D'emploi page 13

OPERATING INSTRUCTIONS
(5) Install the new blades (C, D, E) into the cutter
housing (H). Make sure that the blades are
put inside the cutter housing in proper
position. Insert and tighten a little the left and
middle lock screws (G) with the provided hex
key (AA) so that the blades (C, D, E) will not
come apart from the cutter housing (H).
(See Figure 7)
(6) Re-mount the cutter housing (H) with blades
onto tool. Fully tighten the left and middle
lock screws (G) and finally fully tighten the
right lock screw (G). Make sure that all three
lock screws (G) are installed correctly and
tightened fully. Also make sure that the
cutter housing (H) is mounted straight to tool.
(See Figure 8-a & 8-b)
7
8-a
8-b
13