Chapin 97561 Mode D'emploi page 4

1 1
ASSEMBLE PUMP TO TANK
1 2
INSTALL EXTERNAL BYPASS AND FLOW DIRECTOR VALVE
H-6
C-3
Quick Release Locks
(open /close)
Install external bypass (C-3) and flow director valve (C-4) into pump
quick release ports; engage quick release locks.
* To ensure a good seal a tight fit is used; significant hand force may be
necessary to install bypass fittings.
H-1 H-1
H-6
C-2
C-4
1E
Using H-1 screws, fasten pump(C-2) to face plate with loop
clamp (H-6) inserted between pump and front left screw.
NOTE: DO NOT OVER-TIGHTEN SCREWS.
C-3
Assembled
C-4