Operation; Description Of The Display Icons; Description Of The Status Icons - Beko DD109 Instructions D'installation Et De Fonctionnement

14 Operation

The measured values will be indicated page by page. Depending on the sensor and the settings one or
several values can be indicated on one display page. These settings can be changed via the optional
software or - on request - by BEKO TECHNOLOGIES.
14.1

Description of the display icons

14.1.1 Description of the status icons

ALM1
Data Display DD109
Status display
Indication of measured value:
Only one page of measured values will be shown at a time.
The use can utilize the „arrow up" or „arrow down" keys in order to
scroll through all available pages.
Page view indication:
Shows the current number of pages of measured values as well as the
total number of pages.
These icons show the system status.
Explanation of the single icons:
USB connection icon:
The data display is connected to a PC via USB
Alarm status icon: Alarm 1 (pre-alarm)
Alarm 1 is exceeded
Alarm status icon: Alarm 1 (pre-alarm)
Alarm 1 is undercut
Alarm status icon: Alarm 2 (main alarm)
Alarm 2 is exceeded
Alarm status icon: Alarm 2 (main alarm)
Alarm 2 is undercut
Logger module icon:
WAIT: Time and start conditions are set, waits for start logging
LOG: Logger module is recording data
STOP: Logging stopped
DEL: Logger deletes protocol data
ERR: Error occured during data logging
LOG 100%: Free memory of logger module in percent
CYCLE: Logger memory works in circular mode
Operation
13