Kohler STERLING Finesse 5700 Serie Guide D'installation page 8

Towel Bar Side
Inside Panel
8. Install Rollers
NOTE: Steel side of rollers must be installed against flange.
NOTE: If Rain glass texture is used, texture side faces towards outside of room. If Neo Classique glass pattern is
used, pattern side faces towards inside of shower. Mirror pattern always face towards outside of room.
Outside and Inside Panel
- Assemble rollers, lockwashers and M4 x 0.7 machine screws to the top frame flange with rollers on same side as
towel bar.
- Cut four interlock bumpers to 1" (2.5cm). Install one interlock bumper to each interlock (4).
- Secure rollers.
Middle Panel
- Slide roller bracket onto mounting tab on middle panel. Attach roller bracket to middle panel with two #8 18 x
3/8" panhead screws.
- Install the panel guides in the bottom of the middle panel. One guide on each end of the panel.
- Assemble rollers, lockwashers and M4 x 0.7 machine screws to the roller bracket. Refer to illustration for correct
roller placement.
- Cut four interlock bumpers to 1" (2.5cm). Install interlock bumpers to middle panel interlocks (2).
- Secure the rollers.
C
1017313-2-
Mounting
Tab
Roller
Towel
Bar Side
Panel
Guide
Middle Panel
M4 x 0.7 Machine Screw
Lockwasher
Roller Bracket
Interlock Bumper
Mid Panel Interlock
#8-18 x 3/8"
Panhead Screw
Note: The interlocks are already installed. They
are shown exploded for the purpose of interlock
bumper installation.
Roller
Outside Panel
8
Top Frame Flange
M4 x 0.7
Machine Screw
Lockwasher
Interlock Bumper
Interlock
Sterling