Kohler STERLING Finesse 5700 Serie Guide D'installation page 10

Inside Panel
10. Install Door Panels (continued)
Install Inside Panel (panel closest to bath or shower wall)
- Slide outside and middle panels to side opposite showerhead.
- From outside of the shower, install the inside panel. Position panel with rollers and towel bar towards inside of
shower.
- Lift the inside panel up inside the top track and hang the rollers on the inside rail of the top track.
- Position inside and middle panels until second middle panel guide is aligned approximately at midpoint of inside
panel. Slightly lift the inside panel over and onto the second middle panel guide protrusion.
NOTE: Tilt inside panel away from middle panel. Slide until it is even with middle panel. Panels may bind if not
tilted.
- Roll panels back and forth to make sure they operate smoothly.
- If adjustment is needed, remove the panel. Loosen roller screw(s) and move the roller(s) in slot to align the panel.
Tighten screw(s) and re hang the panel.
Final Panel Adjustment (if necessary)
- Roll the panels back and forth to make sure they operate smoothly and do not interfere with the frame.
- If adjustment is needed, loosen roller screw(s) and move the roller(s) in slot to align panel(s). Tighten screw(s).
C
1017313-2-
NOTE: Tilt inside panel away from middle
panel. Slide until it is even with middle
panel. Panels may bind if not tilted.
Lift inside panel
onto middle
panel guide
Middle
Panel
Guide
10
Sterling