Uline H-725 Manuel page 3

3. Adjust reservoir level: To maintain the optimum
moisture level for the type of tape you are using,
place the water bottle filler opening over one of the
three water level pegs in the water reservoir.
(See Figure 5)
Figure 5
INSTALL UPPER PLATE GUIDE
With top cover open, slide the upper paper guide under
the white wheel.
NOTE: Flange should face up and toward tape
compartment. (See Figure 6)
Figure 6
PAGE 3 OF 12
SETUP INSTRUCTIONS CONTINUED
Min.
Med.
Max.
INSTALL WEIGHT AND COVER PLATE
1. Attach weight to cover plate with locking nut. Slide
weight back for lighter paper tapes (60/70 grade).
Slide weight forward for heavier paper tapes
(70+ grade). (See Figure 7)
Figure 7
Weight
Locking Nut
Cover Plate
2. Take the cover plate/weight assembly and slide the
notches over the pivot shaft on the water reservoir.
(See Figure 8)
Figure 8
LOAD TAPE ROLL
1. Adjust roll guide plates to fit tape width.
(See Figure 9)
Figure 9
Guide Plates
0621 IH-725