Uline RUBBERMAID H-3542 Guide Rapide

π
H-3542
RUBBERMAID
®
AIR FRESHENER DISPENSER
TOOLS NEEDED
Phillips Screwdriver
Wall Anchor x 2
Position dispenser where moving air will disperse
fragrance and neutralizer throughout the entire area,
approximately 3-6' from entrance. Recommended
mounting height is 6' from the floor.
NOTE: This product is designed for commercial
restrooms and is effective in areas approximately
20 x 30' with a ceiling height of 10' (1-4 stall
restrooms, up to 6,000 cubic feet).
MOUNTING WITH ADHESIVE STRIP
1. Peel one side of adhesive strip and adhere to the
rear side of the dispenser. (See Figure 1)
2. Peel other side of adhesive strip and adhere to wall
at desired location. (See Figure 1)
MOUNTING WITH SCREWS
1. Unlock dispenser cover by inserting prongs of key
into two white square holes in bottom of dispenser.
(See Figure 2)
2. Hold the opened dispenser to the wall and mark
screw holes with a pen or pencil. Only mark top
portion of the top hole. (See Figure 3a)
3. Using a 3mm drill bit, drill holes into wall at marked
locations. (See Figure 3b)
PAGE 1 OF 6
CONTINUOUS
3 or 6mm Drill Bit
Drill
(Depends on mounting method)
Screw x 2
1-800-295-5510
uline.com
Hammer
PARTS
Dispenser x 1
MOUNTING
Figure 1
Figure 2
Figure 3
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Dispenser Key x 1
2
3
2
1
Figure 3a
Figure 3b
0321 IH-3542