General Information; Setup Instructions - Uline H-725 Manuel

BEFORE USING THE MACHINE
Follow all safety and operating instructions contained in
this manual. Check local and state codes.
This tape dispenser is for use with gummed tape ONLY.
Uline accepts no responsibility for damage due to
improper use.
INSTALL WATER RESERVOIR
Before using the dispenser: Remove water reservoir from
inside of machine.
1. Remove brush from assembly and wash with soap
and water. Rinse thoroughly and insert back into
water reservoir. (See Figure 1)
Figure 1
2. With the feed lever straight up, take the reservoir in
your left hand and insert the pivot shaft into the slots
on the sides of the dispenser. Move shaft up to the
top of the slots. (See Figure 2)
Figure 2
PAGE 2 OF 12

GENERAL INFORMATION

IF USING OPTIONAL TOP HEATER
Keep the machine clean, dry and in good operating
condition. DO NOT place or operate machine in damp
or humid environments.

SETUP INSTRUCTIONS

3. Slide reservoir down so bottom fits over tab on
dispenser. (See Figure 3)
INSTALL WATER BOTTLE HOLDER
1. Remove plastic brackets from inside unit.
2. Install longer bracket in front slots. Insert in top slot
first and snap into place.
3. Repeat with shorter bracket in rear slot.
FILL WATER BOTTLE
1. Remove bottle from brackets and turn over so filler
opening faces up. (See Figure 4)
2. Press in ball bearing and fill bottle with clean water.
Turn bottle over and place filler opening over
desired water level peg in the water reservoir.
WARNING! Burn Danger – Unplug the top heater
and allow it to cool down before performing
any cleaning, maintenance or repair.
Figure 3
Figure 4
Water
Ball Bearing
0621 IH-725