How To Use - TaoTronics Hello Mode D'emploi

How to Use

Charging
1. Use a micro USB cable and connect the adapter to any
active USB port.
2. The LED indicator will turn red when charging. It will
automatically turn off when the device is fully charged.
Note:
• You can use the adapter while it is charging.
• We recommend charging the unit for at least 2 hours before
using it for the rst time.
Pairing
Pair in TX mode:
1. Set the TT-BA08 to TX mode and connect it to your Non-
Bluetooth® audio transmitting device.
2. Place your Bluetooth audio receiving device, like earphones /
®
speakers, within a 3 feet / 1 meter range and set it to pairing
mode.
3. Turn on the TT-BA08 and tap the power button twice to enter
pairing mode. After approximately 10 seconds, pairing will
complete.
Pair in RX mode:
1. Set the TT-BA08 to RX mode and connect it to your
non-Bluetooth audio receiving device.
®
2. Turn on the TT-BA08 and tap the power button twice to enter
pairing mode.
3. Activate the Bluetooth function on your transmitting device –
®
phone / tablet, and search for the nearby Bluetooth
4. Find "TaoTronics TT-BA08" in the search results and tap on it to
connect. Once connected, the LED indicator will turn solid blue.
Note:
• The adapter will enter pairing mode automatically when
powered on for the rst time.
• The original pairing memory will be cleared after a mode switch.
It will automatically start pairing each time it's powered on.
• The adapter can remember previously paired devices and
will attempt to pair with devices automatically, without going
into pairing mode.
devices.
®
07/08