GNC DayLight Manuel D'installation, D'utilisation Et D'entretien page 18

ENG
Apply the clips provided to the ballpoint endings and insert the assembly into the hole of the lens by sliding back the steel cable and pressing on the
clip head.
Insert the steel cable attached to the ceiling, in the regulator cylinder. Pressing the upper part of the cylinder, the locking mechanism is released
and the cable can be positioned at the preferred height. The excess part of the cable must never be cut. It can be rolled up and hidden among
the heat sink fins.
NOTICE: WHEN YOU INSERT THE CABLE IN THE CYLINDER, THIS MUST BE KEPT UPRIGHT FOR NOT DAMAGE THE MECHANISM.