XLT Ovens X3F3-1832 Serie Manuel D'installation Et Fonctionnement page 110

Table des Matières

Publicité

Oven Initial Start-up Checklist - Remove & Return to XLT Ovens
NOTE:
Take off front panel and remove finger clips (steps 1-3, page 29).
Check for proper installation and placement of return air/end loss plates (step 6, page 42).
Step 2
: Place 1 control box in service position. Hook manometer to top port on gas valve
and document incoming gas pressure. Refer to the Parts & Service Manual for Oven Service
Procedures.
Inlet Pressures: Static Pressure: _________ Is WC within 6-14" WC for Natural Gas or 11-14" WC for LPG.
Step 3
:
Place all control boxes in service position and adjust high bias gas pressure per Parts &
Service Manual. Start each oven and complete form below.
Top Oven
Verify Existing Serial #
Serial #: __________________________________
Left Burner:
High Bias: _______________ Shutter Setting:________
Middle Oven
Verify Existing Serial #
Serial #: __________________________________
Left Burner:
High Bias: _______________ Shutter Setting:________
Bottom Oven
Verify Existing Serial #
Serial #: __________________________________
Left Burner:
High Bias: _______________ Shutter Setting:________
Step 4
: Document the dynamic pressure with all the gas appliances running.
Inlet Pressures: Dynamic Pressure: _______ Is WC within 6-14" WC for Natural Gas or 11-14" WC for LPG.
I&O Manual presented to store operator:
Air-born contaminates:
On-Site dough prep:
Thin Crust
Thick Crust
Notes:
Customer Signature:
Yes
Yes
Yes
Flour
Cornmeal
Grease Other _________________________________
Yes
No
Pan
Screen Other Product: ____________________________
No, contact store owner to adjust. _____Initial
Fingers in proper location:
N/A
Remove finger shipping clips:
Right Burner:
High Bias: _______________ Shutter Setting:________
Fingers in proper location:
N/A
Remove finger shipping clips:
Right Burner:
High Bias: _______________ Shutter Setting:________
N/A
Fingers in proper location:
Remove finger shipping clips:
Right Burner:
High Bias: _______________ Shutter Setting:________
No, contact store owner to adjust. ____Initial
No
Ovens ran for 30 min:
Test cook performed:
Yes
Yes
Date:
No
No

Publicité

Table des Matières
loading

Table des Matières