Speaker Selection - Kenwood KAC-X810D Mode D'emploi

RCA cable and speaker wire connection
RCA cable ground terminal
B.M.S.
OFF
+12dB
REMOTE
Lead terminal*

Speaker Selection

• The rated input power of the speakers that are going to be connected should be greater than
the maximum output power (in Watts) of the amplifier. Use of speakers having input power
ratings that are less than the output power of the amplifier will cause smoke to be emitted as
well as damage.
• Use speakers that have an impedance of 1Ω or greater. When more than one set of speakers
are going to be used, calculate the combined impedance of the speakers and then connect
suitable speakers to the amplifier.
2Ω
2Ω
4 Ω
^
&
INFRASONIC LINE IN
BAND REJECT PHASE
–6dB
NORMAL REVERSE OFF ON 15Hz 25Hz
–12dB
OFF
L
GND
R
POWER IN
SPEAKER
P.CON
BATT. OUTPUT
%
4 Ω
Combined impedance
* : Commercially available parts
Left input
Right input
LINE OUT EXT.AMP.CONT.
L
R
8Ω 8Ω
RCA cable*
CENTER UNIT
(CD receiver, etc.)
Subwoofer (L + R)
4Ω
4Ω
4Ω 4Ω
4 Ω
English
9