Roller Grill WARM IT SIMPLE Notice D'installation Et D'utilisation page 14

Connection of the device
- Check that the tension and the frequency of the electricity network suit to the values
indicated on the descriptive plate.
- Check that neither the cord nor the plug are damaged.
- Make sure that every control knob is positioned on 0.
- Unwind completely the electric power cable and connect it in a plug connected with
the earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly
on the electricity network, confide its connection to a qualified person .
c) Use of device :
Elements of command and display
Command/Display
Thermostat (n°2 on picture)
Green pilot light
(n°1 on picture)
Switch (n°3 on picture) single warm it
Switch (n°3 on picture) double warm
it
Putting on
SINGLE WARM IT
Turn on the thermostat control knob (n°2 on picture) on the 75°C position and
press the switch on (n°3 on picture) the green pilot light (n°1 on picture) ignites.
Once the 15min are over, set the thermostat on the 60°C position.
DOUBLE WARM IT
Turn on the thermostat control knob (n°2 on picture) on the 75°C position during
15 min: the green pilot light (n°1 on picture) ignites.
Once the 15min are over, set the thermostat on the 60°C position
The switch (n°3 on picture) enables to put the rear container on/off. It will be then
automatically regulated by the thermostat.
Temperature setting
The temperature is regulated through the thermostat
Function
Temperature setting
Machine on (pilot light on)
Machine off (pilot light off)
On/off
On/off for the rear container
14