Safety - C.M.O Electro Power IC Mode D'emploi

5. Safety

WARNING : The inobservance of the safety rules and basic precautions can cause damages to
people and objects.
The tampering of the tool or the modification of any of its parts are forbidden. This can cause danger
for the operator and an immediate decay of the warranty relieving the manufacturer from any
responsibility.
 The operator must wear protective clothing such as safety shoes, gloves, glasses, ear caps, etc.,
do not wear large clothes that could block the tool during functioning.
 Take the battery away during the replacement of the accessories.
 Do not touch the moving parts during use.
 Keep the working area clear. The working area must allow safety manoeuvres for the operator:
in particular the floor must be clear from slippery or corrosive substances.
 Keep the children and the unauthorised people away from the tool. Its use is allowed to qualified
personnel, over the age of eighteen and well trained in the tool functioning.
 Check the tool before using it, verify that the screws are not loosen and that the tool is not
damaged.
 Do not drop the tool.
 Do not use the tool besides its functioning, a misuse can break the equipment and cause
damages to people and objects.
 Do not use the equipment with detective parts.
 Do not disassemble or tamper with the tool, it must be repaired only by qualified personnel.
 Only use accessories or spare parts supplied by the manufacturer not to damage the tool.
 For any spare part or repair, please contact the manufacturer or the dealer the equipment has
been bought from.
 After any replacement of damaged parts, check the functioning of the equipment.
 The extensions must be tightened from a minimum of 8,5 mm to a maximum of 13 mm, the
screwing must be forced to allow an efficient blocking.
 Do not use the tool without accessories.
 Do not use the tool to lift loads.
 Do not use the tool as a vehicle jack.
 Do not place any load at the side of the tool during operations, any load placed at the side may
cause serious damages to the equipment, to its accessories and the personnel using it.
 Do not connect more than two extension pipes together, the total length of the connected
extensions should be no more than 100 cm.
 Do not operate the tool for a long time at the maximum or minimum stroke position.
 Choose the proper accessories for the damage to be repaired.
 If the equipment stops during a pushing operation and cannot be removed, take the battery
cartridge away and carry out the unblocking manoeuvre manually keeping the tool body firmly
and turning the cylinder anti-clockwise.
18