C.M.O Electro Power IC Mode D'emploi page 19

USE :
 Before charging a battery taken out from the tool, let it cool for about one hour.
 If you have to charge both batteries wait at least 15 minutes between the two charges.
 Check that the plug is inserted correctly to the power supply, the battery can be inserted only
bringing into line the cartridge with the seat in the battery charger (fig. 2).
 A coloured led will show the charge condition of the battery (fig. 3): red light (battery is charging),
green light (battery is charged).
 After charging the battery, disconnect the battery charger from the power supply (fig. 4).
fig. 2
SAFETY RULES FOR PROPER USE OF THE CONTROLS
 To start operating the tool push the front button on the handgrip, the tool fastness increases as
much as the pressure on the button (see figure n. 5)
 To invert the direction of the rod press on the button on the side of the handgrip (see figure n. 6),
the rotation directions are indicated on the button.
 Always check the direction of the rotation before any operation.
WARNING: Never invert the rotation when the tool is functioning.
fig. 5
fig. 3
17
fig. 4
fig. 6