Warnings; Storage And Unpackage; General Features; Correct Use Of The Product - C.M.O Electro Power IC Mode D'emploi

1. Warnings

Before using this tool, read this manual carefully and follow the instructions you will find in it.
The instruction manual must follow the equipment also in case of its transfer.
Before putting in operation the equipment verify that it has not been damaged during transport, in
case of visible damages notify them to the transport company, do not use the equipment and contact
the manufacturer for information and instructions. The manufacturer declines any responsibility for
the non-observance of what has been written in this handbook.

2. Storage and unpackage

If the tool is used after some time it has been bought, a general check of the correct preservation of
the product must be done. Use the tool only after being sure of its efficiency. The tool must be used
in workshops properly protected by atmospheric phenomena and with a temperature between +10°C
and +40°C. It is advisable to put the carton packages one upon another up to a maximum of 6 pieces,
the carton boxes must be scrapped according to the legal regulations of each country.

3. General features

Electro Power IC is designed and intended for the repairing of damaged vehicles in car body shop.
It is the only pushing-pulling system able to develop a 5 ton capacity in both directions, pushing and
pulling – the changes in capacity depend on the battery charge level.
Thanks to its reduced dimensions and a great ease of handling due to the electrical battery, it avoids
cables and feed hoses that could obstruct the various operations of the repairer.

4. Correct use of the product

SAFETY RULES FOR PROPER USE OF THE BATTERY
 To reduce the risk of damage, only use batteries supplied by the manufacturer.
 Do not expose battery to rain.
 While repairing do not disassemble the battery, if the reassembling is incorrect may cause electric
short circuit or fire. Make the reparation at a qualified service centre.
 Do not charge the battery when the temperature is below +10°C (50°F) or above +40°C (104°F)
 Always cover the battery terminals with the proper cover when the battery cartridge is not in use.
 Avoid storing the battery cartridge in a container with other metal objects.
 Avoid storing the tool and the battery cartridge in locations where the temperature may reach or
exceed +50°C (122°F).
 Do not burn the battery if damaged or completely worn out; it may explode.
 Do not charge the battery in a box or container of any kind. The battery must be placed in a
ventilated area during charging.
 Do not use the battery if gas or inflammable liquids are in the location.
 Place the unused battery in a dry location and out of the reach of children.
 Do not remove any cover or screw to ensure the functioning of the battery.
 Do not clean plastic parts with solvents such as gasoline, thinner, alcohol, ammonia, etc. it may
cause damage or crack the plastic parts. Use a soft cloth lightly wet with soap water.
 Always disconnect the battery charger from the power source before inserting or removing the
battery.
14