Technical Data - camry premium CR7418 Mode D'emploi

5. Press "High" button, the high temperature position is preheating, which is displayed as "H". The high temperature position will
automatically change to "L" low temperature position after 1 hour.
6. Switch off the product and unplug after use.
STORING
Always allow the product to cool down before folding and storing. Roll or fold it loosely and store in a bag. Avoid creating sharp creases
in the product; for example do not store it under other items that may result in bending the inside heating wires. Storage the blanket in a
cool and dry.
CLEANING & AIR DRYING
The product can be machine washed because it is equipped in detachable controllers.
Unplug and remove power cord with controllers from socket (4) to disconnect the power cord before washing.
Fold and pre-soak the product for 15 minutes in a mild soap and lukewarm water solution. Ensure the water temperature is less than
30°C.
When washed, remove the blanket from the net bag and drape it over a clothes line to dry.
Wash on the delicate or gentle cycle for 2 minutes.
Rinse in fresh lukewarm water.
Gently stretch the product to its original size.
Air dry over a clothes line. DO NOT use clothes pegs or clips of any kind.
DO NOT use mothproofing agents on the blanket.
Insulation of the blanket will be damaged if the blanket is dried under the sun, ironed or when mothproofing agents are used. Damage on
the insulation material will cause safety problem.
DO NOT use the product until it is completely dry !
DO NOT iron the product !
Troubleshooting solution: PROBLEM -> CAUSE -> REMEDY
1. If your PROBLEM IS: No Power to Controller / No Indicator Lights showing on Front Display. Or "P" appears. The CAUSE is: Possible
that the controller or coupler is not connected properly. Your REMEDY is: Please turn the controller off and reconnect the coupler
properly. If you cannot troubleshoot, it means the internal connection of the electric blanket is broken. Need to be overhauled or
scrapped.
2. If your PROBLEM IS: No Indicator Lights showing on Front Display when a heat or time setting is selected. Or "E" appearing on the
screen. The CAUSE is: The blanket has been used while folded or crumpled and it has overheated. As a safety measure, the controller
has turned off. Your REMEDY is: Turn the controller OFF, unplug the blanket, lay it down completely flat and leave to cool down, and
then turn on the controller again. If problem persists, it is likely that the blanket has overheated and blown the Over-Temp thermal fuse.
The unit needs to be replaced.
3.If your PROBLEM IS: "C" appearing on the screen. The CAUSE is: The controller has been placed under or inside the blanket and it
has overheated. As a safety measure, the controller has turned off. Your REMEDY is: Turn the controller OFF, unplug the blanket, lay it
down completely flat and leave to cool down, and then turn on the controller again.
4. If your PROBLEM IS: Indicator Lights showing on Front Display but blanket is not heating. The CAUSE is:
a) Detachable Plug from Controller to Blanket is not fitted correctly or has come loose. Your REMEDY is: Ensure the detachable plug is
fitted correctly into the socket on the blanket.
b)The selected heat setting is too low. Your REMEDY is: Increase the Heat setting.
c) Pre-heat time is too short. Your REMEDY is: Allow the Electric Blanket more time to heat up. More time is required depending on the
ambient temperature.
d) Blanket not in contact with body. Your REMEDY is: The blanket may not feel warm to touch unless it is wrapped around your body.
Areas of the blanket not in contact will stay cool.
e) When selected at "H" high temperature setting, the temperature setting will automatically revert to "L" low temperature setting after 1
hour so as to avoid overheating which may cause discomfort. Your REMEDY is: Re-select at "H" or "7" temperature setting.
5. If your PROBLEM IS: The controller is Warm to Touch. The CAUSE is: This is normal. Your REMEDY is: Nothing to do. It is no cause
for alarm.

TECHNICAL DATA

Nominated power input:
Supply voltage:
Dimensions:
Controller:
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins.
Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may effect the
environment. Do not dispose this appliance in the common waste bin.
BITTE AUFMERKSAM LESEN. WICHTIGE HINWEISE, FÜR SPÄTERER
1. Lesen Sie die Bedienungsanleitung, bevor Sie das Gerät verwenden, und befolgen Sie
die darin enthaltenen Anweisungen. Der Hersteller haftet nicht für Schäden, die durch die
bestimmungsgemäße Verwendung des Geräts oder durch unsachgemäße Handhabung
entstehen.
2. Das Gerät ist nur für den Hausgebrauch bestimmt. Nicht für andere Zwecke
CR 7418 / CR 7434
120W
220-240V ~50Hz
180x160 cm
PS7G-H/L
DEUTSCH
DEUTSCH
VERWENDUNG AUFBEWAHREN.
8