ARGENTO Active Bike Mode D'emploi page 21

Adjusting the brake callipers
Active Bike
If the brake is too tight or too loose, use the
Allen key to loosen bolt (C), then adjust the brake
cable, (shorten the brake cable upwards if it is
too tight, if it is too loose, pull the brake cable
downwards) and then, retighten bolt (C). If it is too
loose or too tight, even after following the first
step, adjust the brake pad (fixed) using the Allen
key to move the pad (D) away / closer together.
Active Sport
If the brake is too tight or too loose, use the Allen
wrench to loosen the screw (A), then adjust the
brake cable, (shorten the brake cable at the top if
it is too tight; if it is too loose, pull the brake cable
downwards) and then, retighten the screw (A).
Check the correct alignment between the brake
caliper and the disc. Use the screws (B) and (C)
to adjust the position / alignment on the disc, if
necessary.
20