Water Connection - Candy CDSN D Mode D'emploi

2. WATER CONNECTION

The appliance must be connected to
the water mains using new hose-sets.
The old hose-sets should not be
reused.
l
The inlet and drain hoses can be directed
to left or right.
The dishwasher can be connected to
either cold or hot water, as long as it
is no hotter than 60°C.
l
Water pressure must be between 0,08
MPa and 0,8 MPa.
l
The inlet hose must be connected to a tap
so that the water supply can be cut off
when the machine is not in use (fig. 1 B).
l
The dishwasher is fitted with 3/4" threaded
connector (fig. 2).
l
Connect inlet hose "A" to water tap "B"
with a 3/4" attachment making sure that it
has been properly tightened.
l
If it is necessary, the inlet pipe can be
lengthened up to 2,5 m. The extension
pipe is available from the After Sales
Service Centre.
l
If the dishwasher is connected to new pipes
or to pipes which have not been inuse for a
long time run water through for a few
minutes before connecting the inlet hose. In
this way no deposits of sand or rust will
clog up the water inflow filter.
1
B
2
B
A
79