Star Progetti 206S/1 Instruction Pour Le Montage page 5

WIRELESS REMOTE CONTROL SWITCH
FOR STAR PROGETTI ELECTRIC HEATERS IRK
TECHNICAL INSTRUCTIONS
Congratulations for purchasing our wireless REMOTE CONTROL SWITCH (Receiver). The product you
have purchased was designed and constructed especially for Star Progetti electric appliances.
WARNING
Before using the product read the instructions in this booklet carefully. Star Progetti cannot be
•
held liable for any damage to persons or things caused by non-observance of the instructions
listed below, observance on the other hand will ensure that the appliance is longlasting and
reliable, both electrically and mechanically. Always keep this instruction booklet.
If using this appliance where there are children, supervision by an adult is necessary; this
•
appliance must not be used, without assistance, by children or persons whose physical, sensory or
mental capacities prevent them from applying the necessary safety precautions.
Never use an extension cable with this appliance.
•
Remote switch is designed also for outdoor use
•
1. DESCRIPTION
The mod. 206 remote control switch was designed for use by radio wave transmission with remote on-off
control deviceThe 206 switch is provided with REMOTE CONTROL device (Transmitter). The switch
electrical outlet design is child-proof. All electric appliances connected to the 206 switch can be turned
on and off by remote control or by manually switching. The green LED indicator light on the switch
indicates function status (if the indicator light is on, the switch is ON; if the indicator light is off, the
switch is OFF).
2. SETTINGS AND REMOTE CONTROL FUNCTION
A) HOW TO LINK A CODE
To start program your transmitter with the receiver:
1. Receiver plugged on power. Remember to respect the indication on the marking "↑ TOP "
2. Bring the transmitter near the receiver, push the self program button LEARNING CODE on receiver
about 3 second.
3. Receiver LED will blink slowly, press transmitter selected ON button
4. Receiver connected lamp will on-off twice, code is confirmed and LED stops blinking. Learning
done!
B) TO CHANGE OR DELETE THE CHANNEL
1. Push the learning code about 3 second, LED will blink slowly.
2. Press selected OFF button on transmitter, programmed memory is deleted.
3. Receiver connected lamp will on-off twice for confirmation.
C) REMOTE CONTROL DEVICE – INSERTING THE BATTERY
1. Remove the four screws from the case bottom.
2. Connect the battery 12V battery type A27 and be careful to align the battery polarity as shown on
the case housing.
3. Attach the upper case with four screws.
Receiver has 5 memory settings.
Self program function receiver has 5 memory settings.
It can be programmed to switch on at one time individually or programmed with different combinations
switching at same time. This means One receiver can be programmed into max. 5 different combination
to the transmitter button.
5
(COD.206S/1 – 206F/1)