Abus HomeTec Pro CFW3100 Instructions D'utilisation page 8

correct keycard.
• To program the Wi-Fi Bridge, start by pressing th
button „Add HomeTec Pro / component".
• It is imperative to keep the ABUS keycard in a safe
place even after completing the setup! If you forget
your password, you can reset and reassign it by
scanning the QR code. Do not give the card to third
parties.
To guarantee proper function, we expressly
recommend performing updates in the app and
software/firmware updates for HomeTec Pro
components in a timely manner. The app will provide
information on this. You can also perform the
respective update in the component's settings.
Installation and LED signalling
Plug the WLAN
bridge into a free
socket (230 V)
within a
maximum
distance of
5 metres from
the HomeTec Pro
door lock actuator
CFA3100.
14
The LED of the WLAN bridge signals the following:
LED LED Description
colour status
shining Normal operating status
flashing -
shining Boot process
(further steps pending)
flashing Boot process (in action)
shining Search process for
updates/licences
flashing Installation of updates/licences
shining Network (WLAN) search
flashing Ready for network (WLAN)
configuration
shining -
flashing Error/problem is present or
factory reset* has been started
* Perform a factory reset: Press the recessed button
on the underside of the WLAN bridge with a pointed
object for approx. 10 seconds.
15