Alarm Recording; Connecting An Alarm Sensor; Setting The Alarm Speed And Duration - Sony SVT-96LP Mode D'emploi

Alarm Recording

You can use a door switch or alarm sensor to trigger
alarm recording. You can make alarm recording in
recording mode, stop mode and power off mode with
the selected recording speed.

Connecting an Alarm Sensor

Commercially available
switching box, etc.
Setting the Alarm Speed and
Duration
1
1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "3" of the MAIN
MENU flashes on the monitor screen.
to ALARM OUT
to COM
to ALARM
to COM
IN
2-5 6
3
Press MENU B.
The ALARM SET menu appears.
ALARM SET
ALARM MODE
ALARM SPEED
ALARM DURATION
ALARM DATA REC
TAPE END WARN.
CLOG DETECTION
SERIES REC
< >
NEXT PUSH
+ –
SELECT : DATA SET : / RETURN : MENU
4
Press MENU V to move the flashing to the setting
of ALARM SPEED and set it by pressing MENU +
or –.
ALARM SET
ALARM MODE
ALARM SPEED
ALARM DURATION
ALARM DATA REC
TAPE END WARN.
CLOG DETECTION
SERIES REC
< >
NEXT PUSH
+ –
SELECT : DATA SET : / RETURN : MENU
When TAPE in the GENERAL SET menu is set
to E-180:
Set ALARM SPEED to 6H, 18H or NC by
pressing MENU + or –.
6H: for recording in 6-hour mode
18H: for recording in 18-hour mode
NC: for recording at the same speed as before the
alarm was received.
When TAPE in the GENERAL SET menu is set
to E-240:
Set ALARM SPEED to 8H, 24H or NC by
pressing MENU + or –.
8H: for recording in 8-hour mode
24H: for recording in 24-hour mode
NC: for recording at the same speed as before the
alarm was received.
A1
6H
20sec
OFF
COUNTER
ON
OFF
A1
6H
20sec
OFF
COUNTER
ON
OFF
33