Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONTROL PANEL:
Power ON/OFF button
1
Timer button
2
Swing mode button
3
Remote control
The remote control has a pre-installed lithium CR2025 battery.
Remove the protective tab to activate the remote control battery.
Inserting / replacing the remote control battery:
1) Push the security lock.
2) Pull out the battery tray and remove the old battery.
3) Place a new CR2025 battery into the battery tray with correct polarity (+/-) as indicated.
4) Place battery tray back in the slot.
A
B
F
E
Modes
Power ON/OFF
Connect the device to an easily accessible power socket. When connected, a beep sounds
and the LED indicators on the display panel light up in sequence indicating it is performing
its diagnostic test and is in standby mode.
Press the power ON/OFF button on the device
device. While pressing, a beep sounds.
When switching on the device it automatically starts in FAN mode - Normal airflow and low
FAN speed.
To switch off the device, press the power ON/OFF button on the device
again. A beep sounds and the LED indicators on the display panel light up in
A
control
sequence indicating it is performing its diagnostic test and is in standby mode.
Note! When switching off the device when it is in cooling mode, the FAN speed will go to
maximum speed for up to ± 30 seconds.
To switch off the device completely, remove the power plug from the power socket.
FAN Speed button (low-medium-high)
4
Cool button
5
FAN selection button (normal-natural-sleep)
6
Ionizer button
7
C
REMOTE CONTROL:
D
Power ON/OFF
A
FAN speed
B
C
Cool mode
G
Swing mode
D
Timer
E
FAN selection
F
Ioniser
G
EN 06
or remote control
1
A
to switch on the
or remote
1
Publicité
Table des Matières
