Dutch originals DO-CH-ACL060DRT Manuel D'utilisation page 10

Refroidisseur d'air mobile 6l
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To achieve a longer cooling function, fill the ice packs with water and freeze them before
use.
Note! Do not fully fill the ice packs with water, as they will extend when they freeze!
Ionizer mode
To activate the ionizer function on the device, press the Ionizer button
G
remote control
While pressing, a beep sounds and the ionizer LED indicator lights up on the display panel.
To switch off the ionizer function on the device, press the Ionizer button
or remote control
lights up on the display panel.
Filling the water tank:
• Switch off the device and disconnect it from the mains electricity supply.
• Open the water filling reservoir cover
• Remove the drain plug
• Add clean fresh water in the reservoir (max 6L).
• Note! The water will drain into the water tank
• Place the drain plug
• The frozen ice packs, for extended cooling performance, can be placed in the water filling
reservoir.
• Respect the MIN & MAX water levels. There is an indicator at the front of the device
4
.
• Close the water filling reservoir cover
• Do not move the device while operating, to avoid water spilling.
Note!
• DO NOT OPERATE THE COOLING MODE WITHOUT WATER IN THE WATER TANK
• ONLY USE CLEAN FRESH WATER, AND DO NOT ADD ANY ADDITIVES!
• DO NOT USE WATER ABOVE 40°C
Emptying the water tank:
• Switch off the device and disconnect it from the mains electricity supply.
• Open the water filling reservoir cover
• Remove the drain plug
• Drain the water from the water filling reservoir.
• Place the drain plug
• Close the water filling reservoir cover
• Remove the drain plug
• Drain the water from the water tank.
• Place the drain plug
Timer setting
The timer can be set from 0 to 7 hours.
Press the Timer button on the device
setting.
Each press will add 1 hour to the timer setting and the corresponding LEDs light up on the
display panel.
.
again. While pressing, a beep sounds and the ionizer LED indicator
G
in the water filling reservoir!
11
back in the water filing reservoir.
11
in the water filling reservoir.
11
back in the water filing reservoir.
11
of the water tank (in the bottom rear of the device)
13
back in the water tank (in the bottom rear of the device).
13
12
in the bottom of the device.
10
12
12
12
or remote control
2
EN 08
on the device or
7
on the device
7
E
to select the desired timer

Publicité

Table des Matières
loading

Table des Matières