Operating Notes; Charging; Inserting A Transmitter Into The Charger - AKG CU700 Mode D'emploi

• Rechargeable batteries (those included or those you may buy later) are delivered un-
charged or partially charged. Therefore, you will need to charge each new battery before
using it.
• The battery capacity indication will work best if you charge the batteries fully using the
CU 700 charger.
• If you replace the rechargeable batteries inside a transmitter be sure to fully charge the
batteries in order to calibrate the charging control system.
• Battery life depends on battery quality. Do not use any rechargeable batteries other than
the same type as those included with the charger.
Each charging slot features a tricolor STATUS LED that indicates the current operating status of the re-
spective charging slot (">...<" marks an LED flashing in the respective color):
STATUS LED
---
orange
red
green
>red<
blue
1. Check that rechargeable batteries are inside the
transmitter battery compartment.
If there is no battery inside the battery compart-
ment, do not place the transmitter in a charging
slot before you inserted rechargeable batteries
into the transmitter.
2. Insert the transmitter into the charging slot so
that the display on the transmitter faces the LEDs
on the charger. The charger will automatically
power the transmitter via the charging contacts.
3. Never switch the transmitter ON during the
charging cycle. This may cause the charger to
falsely indicate a completed charging cycle be-
fore charging is actually completed.
• To avoid damaging the charger, do not try to charge dry batteries.
The charger is ready to operate, no transmitter is inserted in a
charging slot.
The batteries inside the inserted transmitter are being checked.
Battery temperature is above 40°C or below 5°C. LED flashes until
temperature is within specified range.
The batteries are being charged.
The batteries are fully charged; the charging cycle is completed.
Error.
Data communication for computer monitoring is active.
5

Operating Notes

STATUS
CU
700

Charging

Note
Table 1: STATUS LED
indications
Inserting a Transmitter into
the Charger
Fig. 1: Inserting transmitters
into the CU 700 charger.
L
!
NOTICE
7