Section 3: Programming With Easy-Set Logic - Orbit 94874 Manuel De L'utilisateur

only connect one valve to
each terminal (station) or
damage will occur
station 1
strip wire
Push in
Figure 4
24VAC SENSOR COM 1 2 3 4 5 6
Push tab
upward to
24VAC SENSOR COM 1
release wire
Figure 5
Your timer is equipped with the simple "push-in"
terminals for easy connection . Connect common wire
to the common terminal . Connect remaining wires to
corresponding terminal locations .
4. Connect Electrical Transformer Power
Connect power connector to the timer . insert the
transformer into an 220V electrical outlet . See Figure 5
5. Activate Battery
one lithium CR2032 battery (included) is required
to retain the program in memory during power loss .
Annual replacement is recommended .
Remove the plastic strip to activate the pre-installed
battery . (See page 12 for battery replacement)
Note: The battery alone will not operate the valves in
your sprinkler system. The sprinkler timer has a built-in
transformer that must be connected to an AC voltage source.
2 3 4 5 6
Remove plastic
strip to activate
battery
Section 3: Programming with
Easy-Set Logic
™
A note about multiple programs
Your sprinkler timer provides the flexibility of using 2
independent programs (A, B) . The programs are where
you store all of your sprinkler settings . each program
consists of a group of stations set to specific start
times and run times . Multiple programs allow you to
run different valves on different days with different
run times . While many applications only require one
program (A), using multiple programs (A, B) can be
useful for drip areas, newly planted lawn, or rotary
sprinkler stations . Using programs to group stations
with similar water needs will maximize irrigation
efficiency .
Primary programming can be accomplished in just a
few basic steps .
Primary Programming
Press the [ReseT] to clear any previous factory
programming
1. Set Clock
• Turn dial to [SET CLOCK].
• Press the [+/–] buttons to set the current time of day.
8 8 9 9
Tip: To increase or decrease more rapidly, hold down
either the [+] or [-] buttons until the display goes into
rapid advance mode.
• Press the [   ] buttons to set am/pm .
• Turn dial to accept time .
2. Set Date
• Turn dial to [seT dATe] .
• Press the PRoGRAM button to select which
program you'd like to set .
• Press the [   ] buttons to select which stations
you'd like to set
• Y/M/d will appear (blinking letter indicates selection) .
• Press the [+/–] buttons to set the correct year,
then press [eNTeR] or [   ] .
• Press the [+/–] buttons to set the correct month,
then press [eNTeR] .
• Press the [+/–] buttons to set the correct date .
• Turn dial to accept date .
3. Start time
• Turn dial to [sTART TiMe] .
• Press the [+/–] buttons to select time you'd like
your watering to begin . (time will adjust in 1
minute increments)