Daitsu RG51B1/EU Manuel Du Propriétaire page 11

CONTENTS
Handling the remote controller ..............................................................16
Remote controller Specifications...........................................................17
Function buttons .................. ..................................................................18
Indicators on LCD ...................................................................................20
How to use the buttons ..........................................................................21
Auto operation.........................................................................................21
Cooling/Heating/Fan operation..............................................................21
Dehumidifying operation .......................................................................22
Swing operation......................................................................................22
Timer operation.......................................................................................23
ECONOMY operation .............................................................................26
15
Handling the remote controller
Location of the remote controller.
- Use the remote controller within a distance of 8 meters from
the appliance, pointing it towards the receiver. Reception is
confirmed by a beep.
CAUTIONS
- The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
- Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat.
- If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
- If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer.
Replacing batteries
The remote controller is powed by two dry
batteries(R03/LR03X2) housed in the rear
part and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and insert the new
batteries,placing the(+) and (-) ends correctly.
(3) Reattach the cover by sliding it back into
position.
NOTE: When the batteries are removed, the
remote controller erases all programming.
After inserting new batteries, the remote
controller must be reprogrammed.
16