Troubleshooting And Repairs; Introduction; Troubleshooting - Heiniger EVO 3 Traduction De La Notice Originale

5

Troubleshooting and repairs

This product has been developed and assembled using the best individu-
al components available. It is designed to give longevity and high perfor-
mance. If spare parts are used during the life of this product, please en-
sure that they are genuine Heiniger parts. Failure to use genuine Heiniger
spares may reduce the performance of this precision engineered product
and will void any warranty claim.
5.1

Introduction

WARNING!
The following troubleshooting guide will aid in determining pro-
blems and offer a solution. An authorised service point may only
carry out solutions that appears against a dark background.
An authorised service agent is to be contacted in the event of
malfunctions that are not contained in this manual.
5.2

Troubleshooting

Malfunction
Motor does not run.
Motor always switching
off.
Motor system does not
switch off by lock up.
12
Cause
No power.
Cable faulty.
Switch faulty.
Motor faulty.
Control unit faulty.
Capacitors faulty.
Cutter blocked.
Mechanical damage in
the shearing handpiece,
in the rigid drive downtu-
be or flexible drive.
Bearing in the shearing
plant faulty.
The belt is slipping.
EVO Shearing Plant – Translation of the original instructions
Rectification
Power supply and/or fuse
faulty.
Have the cable replaced.
Have the switch replaced.
Have the motor replaced.
Have control unit replaced.
Have the capacitors re-
placed.
Remove blockage.
For the purposes of fault
finding first of all uncouple
the shearing handpiece
and restart the plant. If the
fault persists, uncouple
the rigid drive downtube
or flexible drive from the
shearing plant. Rectify any
damage.
If the fault still persists,
then have the shearing
plant repaired.
Have the bearing replaced.
Have the belt replaced.