Before Using - Panasonic DOUBLE FEATURE PV-D4744S-K Manuel D'utilisation

Before Using

Congratulations
on your purchase of one of the most
sophisticated and reliable products on the
market today. Used properly, it will bring you
years of enjoyment. Please fill in the information
below. The serial number is on the tag located
on the back of your DECK.
• Date of Purchase
• Dealer Purchased From
• Dealer Address
• Dealer Phone No.
PV-D4744S-K
• Model No.
• Serial No.
Accessories
Remote Control
EUR7724KA0
Loading the Batteries
1) Open cover.
2) Insert batteries as
marked.
3) Close cover.
Battery replacement caution
• Do not mix old and new batteries.
• Do not mix alkaline with manganese batteries.
Record/ Playback Time
Only use tapes with the
Type of Video Cassette
Tape Speed
Setting
T120
SP
2 Hours
(Standard Play)
SLP
6 Hours
(Super Long Play)
4
D4744S-K P1-25 (040202).p65
Head Cleaning
Playing older or damaged tapes may eventually
cause video heads to become clogged.
Video Head Clog Sensor
During playback, this screen
appears if clogging is detected.
To remove screen, press PLAY
on the remote or DECK.
• Use "dry" type head cleaning cassette only.
(Part No. NV-TCL30PT is recommended.)
• Follow cleaning tape instructions carefully.
Excessive use of tape can shorten head life.
• If head clog symptoms persist, contact your
Batteries 2 "AA"
nearest Factory Servicentre or authorized
Servicentre (see p. 61).
Cleaning DECK
RF Coaxial Cable
Use a soft cloth or dusting attachment of a vacuum
LSJA0418
cleaner to remove dust from the ventilation holes on
the back sides and bottom of the cabinet.
Plastic surfaces are easily scratched and can be
marred by alcohol and various solvents.
Avoid excessive use of oil-based furniture polishes
since the materials used in the cabinet will
accumulate more dust. We recommend using a
non-abrasive, antistatic cleaner and polisher.
Features for a Quality Picture (VCR)
Digital Auto Picture
Automatically controls the video output signal for
less noise depending on the tape condition.
Digital Auto Tracking
Continuously analyzes the signal and adjusts for
optimum picture quality.
Manual Tracking Control
(to reduce picture noise)
Use during Playback and Slow Motion mode to
reduce picture noise.
Press CH (TRACKING)
or on DECK until the picture clears up.
To return to Auto Tracking, press POWER off, then
on again a few seconds later.
mark in this DECK.
T160 T180
2 Hours
3 Hours
40 Minutes
V-Lock Control (to reduce picture jitter)
In Still mode, CH (TRACKING)
8 Hours 9 Hours
V-Lock control.
4
V I DEO HEADS MAY
NEED CLEAN I NG
PLEASE I NSERT HEAD
CLEAN I NG CASSETTE
OR REFER TO MANUAL
END : PLAY
/ on the remote control
/ operate as a
2004/02/02, 15:10