Panasonic DOUBLE FEATURE PV-D4744S-K Manuel D'utilisation page 25

Combiné magnétoscope-lecteur dvd
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

*Important: If a remote control button does not work when pressed,
Review, Replace or Clear Program Contents:
(Recording is not in progress)
1
Press PROG
to display Program List.
2
P DT START
STOP
CH SPD
1
13
2:00p
3:20p 02 SLP
2 14
7:00p
7:30p 10
SP
3 -- --:-- --:-- --
--
4 -- --:-- --:-- --
--
CANCEL : ADD/DLT
SELECT :
SET : SET
EXIT
: PROG
3
To Replace program...
P DT START
STOP
CH SPD
1 13
2:00p
3:20p 02 SLP
2 14
7:00p
7:30p 10
SP
3 -- --:-- --:-- --
--
4 -- --:-- --:-- --
--
SELECT :
SET : SET
EXIT
: PROG
or
To Clear program...
P DT START
STOP
CH SPD
1
-- --:-- --:-- --
--
2 14
7:00p
7:30p 10
SP
3 -- --:-- --:-- --
--
4 -- --:-- --:-- --
--
SELECT :
SET : SET
EXIT
: PROG
4
Press PROG
to end the programming.
Notes
• If you are using a Cable Box, the VCR's channel for Timer Recording must be set to
the Cable Box input channel and Cable Box must be manually set to the desired
channel. Cable Box power must be left on.
• 2 minutes before Timer Recording is performed, "PLEASE PREPARE FOR TIMER
REC" appears and Timer Indicator flashes.
Be sure a cassette with record tab is loaded and DECK is in Stop mode.
• If a power interruption occurs while programming the timer, the timer program(s) may be
cancelled. If "TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION"
appears on-screen, please re-enter the timer programs.
• If the start time for Timer Recording comes up during recording and playing back,
Timer Recording will not be performed.
Important notes when using DSS Receiver
• When recording programs via DSS Receiver, DSS Receiver must be left on.
• When recording programs via an antenna or cable, DSS Receiver must be turned off.
D4744S-K P1-25 (040202).p65
press the VCR button on the remote and try the button again.
Press
to select number.
Repeat Step 2 (p. 24)
to set new programs.
Press ADD/DLT.
25
To cancel a Timer
Recording in progress...
Hold down STOP in VCR mode for
a few seconds to cancel the Timer
Recording.
( The "TIMER" Indicator goes out
on Multi Function Display.)
• Any future daily or weekly recording
will be performed as programmed.
2004/02/02, 15:10
25

Publicité

Chapitres

Table des Matières
loading

Table des Matières