Operation; Applications - Scotts 51519S Mode D'emploi

NOTE: Whening using the grass catcher, do not install the
mulching plug.
•
Disconnect power supply.
•
Lift the rear discharge door.
•
Lift the grass catcher by its handle and place under the rear
discharge door so that the hooks on the grass catcher are
seated onto the slots on the mower housing.
•
Release the rear discharge door.
•
Connect to power supply when you are ready to mow.
SETTING BLADE HEIGHT
See Figure 7
When shipped, the wheels on the mower are set to a low-cutting
position. Before using the mower for the first time, raise the
cutting position to the height best suited for your lawn. The
average lawn should be between 1-1/2 in. to 2 in. during cool
months and 2 in. or higher during hot months.
To adjust the blade height:
•
Disconnect power supply.
•
To raise the blade height, press inward on the height
adjustment lever and move it toward the back of the mower.
A is the highest blade setting.
•
To lower the blade height, press inward on the height
adjustment lever and move it toward the front of the mower.
B is the lowest blade setting.
•
Connect to power supply when you are ready to mow.
DANGER:
Risk of death by electrocution or electric shock or serious
personal injury if power lines or electric cords are contacted.
Never operate mower over electrical sources, cords or wires.
WARNING:
Do not allow familiarity with this type of product to make
you careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to comply
with ANSI Z87.1. Failure to do so could result in objects being
thrown into your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recommended
by the manufacturer of this product. The use of attachments or
accessories not recommended can result in serious personal
injury.
WARNING:
Always inspect mower for missing or damaged parts and blade
for damage, uneven, or excessive wear prior to use. Use of the
mower with damaged or missing parts can result in serious
personal injury.
ASSEMBLY
Fig. 6
Fig. 7

OPERATION

WARNING:
Always disconnect from power supply when you are
assembling parts, making adjustments, cleaning, or when not
in use. Following these instructions will prevent accidental
starting that could cause serious personal injury.

APPLICATIONS:

You may use this product for the purpose listed below:
•
Mowing your lawn.
WARNING:
To avoid accidental starting that could result in serious
personal injury, always disconnect from power supply
when moving or transporting the mower.
INSTALLING / REMOVING EXTENSION CORD
See Figure 8
•
Insert the female end (C) of
the extension cord (A) into the
product as shown.
•
Connect the male end of the
extension cord to the power
source.
•
Make sure the extension cord is
secured on the cord retainer (B)
before beginning
9
Model 51519S
Hook
Slot
Height Adjustment
Lever
Fig. 8
B
A
operation.
C