Maintenance - Scotts 51519S Mode D'emploi

MOWING TIPS
NOTE: Inspect the area where the mower is to be used,
and remove all stones, sticks, wire, bones, and other
debris that might be thrown by the rotating blade.
•
Release the blade control lever to turn the mower
OFF when crossing any graveled area (stones can be
thrown by the blade).
•
Set mower to the highest cutting height when mowing
on uneven ground or in tall weeds.
•
Walk at a steady pace. Overlap the cutting rows. Do
not let the grass get too tall. If the grass gets too long,
start at the highest cutting position and work down to
the desired cutting height.
WARNING:
If you strike a foreign object, stop the motor. Thoroughly
inspect the mower for any damage. Repair any damage
before operating the mower. Excessive vibration of the
mower during operation is an indication of damage.
Thoroughly inspect the mower and repair any damage
before operating the mower.
WARNING:
Before performing any maintenance, make sure the
power supply is disconnected to avoid accidental
starting and possible serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING
:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
an authorized service center for assistance.
OPERATION
EMPTYING THE GRASS CATCHER
See figure 11
•
Stop mower and allow
blades to completely stop.
•
Disconnect power supply.
•
Lift the rear discharge
door.
•
Lift the grass catcher by
its handle to remove from
mower.
•
Empty grass clippings.
•
Lift the rear discharge
door and reinstall the
grass catcher as
described earlier in this
manual.
•
Connect to the power
supply when you are
ready to mow.

MAINTENANCE

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal
injury.
NOTICE:
Never use a hose, water, or any liquids to clean the
lawn mower, as water can damage electronic
components. Remove any buildup of grass and leaves
on or around the motor cover. Wipe the mower clean
with a dry cloth occasionally.
Periodically check all nuts and bolts for proper tightness
to ensure safe operation of the mower.
11
Model 51519S
Fig. 11