SEKUR POLIMASK Serie Manuel D'utilisation Et D'entretien page 14

•
suitability evaluation for donning by fit-test
First of all make sure that eyeglasses are compatible with the half mask, and that they allow a satisfactory vision, without
compromising the seal on the face of the half mask itself, also through the evaluation din a correct fit factor (FF - seal
factor). The use of POLIMASK halfmasks with filters implies that the above conditions for the use of filtering devices are
met. In case of doubt, self-contained breathing apparatuses are to be used. When the hazards call for respiratory tract
protection and also for the use of protective equipment, the compatibility of these devices with the mask must be
carefully tested. These additional protection measures must not jeopardize the full effectiveness of the respiratory
protective equipment. The hazards of this kind can be the following:
- Liquid or gaseous substances which are harmful in contact with skin
- Toxic substances which are irritating to skin
- Radiations
- Mechanical stress
- Explosions in the ambient atmosphere
- Oxygen-enriched atmosphere
In case of doubt of the suitability of the product with reference to your intended work condition, consult the safety
manager the occupational physician, or the customer service of D.P.I. s.r.l. which is at your disposal for any assistance,
explanation, advice and information you might need. Consult the reverse of the cover of this manual for the address
and telephone numbers.
6 Marking
POLIMASK series half masks are CE marked according to the provisions of the EU Regulation 2016/425 and subsequent
modifications since the tested samples met the requirements of EN 140. In fact they are marked as follows:
Polimask 100/2
=
Half mask body
manufacturers
identifying Logo
Polimask =
Product line Half mask body
name
Model name Half mask body
EN 140:98 =
Half mask body
Reference Norm
= CE
Mark and
number of the
Half mask body
Notified Body
which performs
the production
control.
XX = year of
Half mask body
production of the
(inside)
device
year of
Neck buckle (XX
production of the
last two digits)
harness
XX = year of
production of the Valve
exhalation valve
XXXX XXXX =
On the
Spare part code
component
number
Packaging
EN 140:98 = Reference Norm
= Please read the attached use and maintenance handbook
XX/YY = Month (XX) and year (YY) of expiration date
Faceblank distinguishing colour:
Material
POLIMASK ...(Rubber)
POLIMASK ... SIL (Silicon)
Polimask 230 Polimask 330
Half mask body Half mask body
Half mask body Half mask body
Harness (outside) Harness (outside)
Harness (outside) Harness (outside)
Harness (outside) Harness (outside)
Half mask body Half mask body
(inside) (inside)
Inside of the Inside of the
harness (XXXX harness (XXXX
four digits) four digits)
Valve Valve
On the On the
component component
Half mask body
BLACK
YELLOW
Polimask 2000 Polimask 2000
Beta Gamma
Half mask body Half mask body
Half mask body Half mask body
Harness (outside) Harness (outside)
Neck buckle Neck buckle
Half mask body Half mask body
Half mask body Half mask body
(inside) (inside)
Neck buckle (XX Neck buckle (XX
last two digits) last two digits)
Valve Valve
On the On the
component component
Colour of the half mask harness
ORANGE
Polimask 2000
Delta
Half mask body
Half mask body
Harness (outside)
Neck buckle
Half mask body
Half mask body
(inside)
Neck buckle (XX
last two digits)
Valve
On the
component
BLACK