Measurement And Correction Of Umbalance; Placing The Wheel On The Wheel Balancer; How To Compensate Umbalance Of Flanges Using Afc Function - Fasep B140.G2.T Manuel De L'utilisateur

Fasep 2000 srl
Balatron B140.G2.TC: User's Manual
5

MEASUREMENT AND CORRECTION OF UMBALANCE

5.1

Placing the wheel on the wheel balancer

5.1.1 Select the cone or flange suitable for the wheel to be balanced.
G
NOTE: the operation of centering and tightening of the wheel on the flanges is of basic importance for correct balancing.
Good results depend on proper performance of these procedures.
Clean accurately all cones, shaft and adappter surface before placing the wheel on the wheel balancer.
!
CAUTION:
5.1.2 Lower the balancer through lift handle
5.1.3 Lock the shaft through brake handle
5.1.4 Mount the flange
5.1.5 Near the wheel balancer to the wheel
5.1.6 Mount the wheel and the mating flange on the shaft
5.1.7 Lock the wheel on the shaft through locking handle
5.1.8 Lift the balancer through lift handle
G
NOTE: Before measuring the umbalance restore balance in the fully raised.
5.2

How to compensate umbalance of flanges using AFC function

G
NOTE: This operation allows to put compensate unbalance of flange and other accessories.
5.2.1 Lock the required flange on the shaft without the wheel.
HOW TO TURN ON AFC FUNCTION
The ZERO led blinks.
The ZERO led is on.
Always make sure flanges are correctly locked on the motor shaft and wheel is correctly locked on the
flange being used.
HOW TO TURN OFF AFC FUNCTION
5-1
01 June 2013
Remove the flange.
The ZERO led switch off.
Rev. 1.3