G - Using The Product With A Thomson Network Video Recorder; H - Using The Product With A Thombox; Automatic Configuration - THOMSON 512392 Manuel D'utilisation

g - uSiNg ThE prOduCT WiTh A ThOMSON NETWOrK VidEO rECOrdEr

Your camera is compatible with the ONVIF protocol
and can be paired with a network video recorder.
• Connect your camera to the network or one
of the recorder network sockets and run a
camera search on the recorder.
Your network recorder needs the following
information:
• The IP address of your camera: if the recorder
cannot find the camera automatically, provide
it with the IP address discovered by the 'IP
Camera Search Tool' supplied on the CD (see
paragraph D - 1 - ACCESS TO CAMERA
CONFIGURATION)
• Your camera's ONVIF port: if the recorder does
not discover this automatically, the default port
number is 888.
• A username and password: these are the same
usernames and passwords you use to connect
to your camera (default username = admin;
default password = none)
• When you have entered all the information into
the recorder, add the camera in the same way

h - uSiNg ThE prOduCT WiTh A ThOMBOX

1 - AUTOMATIC CONFIGURATION

• Your camera is optimised for use with a
Thombox. Go into the interface of your
Thombox to pair your camera and click on
'Ajouter une nouvelle caméra [Add new
camera]' in the Cameras widget:
• Tick the box on the row corresponding to your
camera, then click Ajouter [Add].
• If your camera has not been detected, enter
the address of your camera as indicated by the
IP Camera Search Tool software:
14
en
Motorised 720P Hd WiFi iP caMera
tick the row
corresponding to
your camera
as you would with the original cameras. After
a few seconds, your camera feed will appear
beside the feeds from your original cameras.
You will then be able to record videos onto the
recorder's hard disk and use the recorder's
motion detection, just like with the original
cameras. You can also control your camera's
motors and continue to use your IP camera as
before with your smartphone or computer.
• Warning: the default address of your camera
ends with ':88'; you should also copy it and
the IP address of your camera in the Thombox
widget. Tick the relevant camera, then click on
Ajouter [Add].