Assembly Instructions - Troy-Bilt TB20CS Manuel De L'utilisateur

INSTALL AND ADJUST THE D-HANDLE
1. Push the D-handle down onto the shaft housing so that the
handle slants towards the shaft grip (Fig. 1). The squared
bolt hole in the handle is to the right.
Shaft Grip
Shaft Housing
Minimum 6 inches
(15.24 cm)
Bolt
2. Insert the shoulder bolt into the squared hole in the handle
and push through. On the left side of the handle, place the
washer on the bolt, then screw the wing nut onto the bolt.
Do not tighten until you make the handle adjustment.
3. Rotate the D-handle to place the grip above the top of the
shaft housing. Place it a minimum of 6 inches (15.24 cm)
from the end of the shaft grip.
4. While holding the unit in the operating position
(Fig. 2), position the D-handle to the location that provides
you the best grip.
5. Tighten the wing nut until the D-handle is secure.

ASSEMBLY INSTRUCTIONS

D-Handle
Tighten
Wing Nut
Washer
Fig. 1
Fig. 2
INSTALL THE CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment shield
on your unit is not installed.
WARNING:
Never operate the trimmer without
the cutting attachment shield in place to prevent
serious personal injury.
1. Place the cutting attachment shield onto the shaft housing.
Be sure the guard mounting bracket slides into the slot on the
edge of the cutting shield. Rotate the shield into place,
counterclockwise. The holes in the guard mounting bracket
and cutting attachment shield will line up (Fig. 3).
Shaft Housing
Cutting Attachment
Shield
2. From inside the cutting attachment shield, push the square bolt
through the hole until the threaded end protrudes through the
guard mounting bracket (Fig. 4).
Guard
Mounting
Bracket
Square Bolt
3. Put the washer on the bolt, then screw the wing nut onto
the bolt and tighten. Figure 5 shows the installation
process from underneath the unit.
Square Bolt
Cutting
Attachment
Shield
Cutting Attachment and Shield: Underside View
Guard
Mounting
Bracket
Fig. 3
Washer
Wing Nut
Fig. 4
Hole
Washer
Wing Nut
Fig. 5
5