Shutting Down; Maintenance And Care - Windsor Recover 17 Manuel D'instructions

– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– If desired, the appliance can be retrofit-
ted with a switch-off mechanism for
non-conducting liquids.
– After having completed the wet vacuum
operation clean the flat pleated filter,
the electrodes and the container and let
dry.
Clip connection
The suction hose is equipped with a clip
system. All C-40/C-DN-40 accessories can
be connected.
Operation
Turning on the Machine
Plug in the main plug.
Turn on the machine.

Shutting down

Turn off the machine.
Pull out the electrical plug.
Empty the container.
Vacuum and wipe the machine inside
and outside.
Wind up the suction hose and mains ca-
ble.
Place the machine in a dry room and
secure it from unauthorized use.

Maintenance and care

Warning
First remove the mains plug before doing
any job on the vacuum cleaner.
Replacing the flat-fold filter and the
exhaust filter
Open filter door.
Replace the flat pleated filter.
Replace the exhaust filter.
Close the filter door, it must lock into
place.
7
English