Table des Matières
Publicité
1.1 Machine transport and handling
The machines are protected during transport by particularly sturdy packing which is resistant to various stresses.
In spite of its low dimensions the packaged machine cannot be transported manually.
The correct lifting system to use is a fork lift or pallet conveyor/mover, making sure that the weight of the machine is evenly distributed.
For highest safety during transport and handling, the equipment contained inside the packing has been screwed down to the pallet.
The packing has printed warning symbols that represent the instructions to follow during transport and storage in order to assure that no
damage is caused to the equipment during loading and unloading operations
The symbols printed on our packing are as follows (UNI ISO 780):
HANDLE WITH CARE
THIS WAY UP
Stacking limits for the goods with regard to transport and storage are as follows:
Type*
A
B
C
D
E
* See technical documenation
WARNING!! The values shown in the table are valid for packaged goods that have been properly placed one on top of the other. Because
the centre of gravity of the equipment is not the same as its geometrical centre, take care when tilting the package during handling
operations.
1.2 Operazioni di disimballo e posizionamento macchina
We recommend unpacking the equipment as soon as it arrives in order to verify that it is complete and that it has not been damaged
during transport. Damage, if any, must be communicated immediately to the carrier, even in the event that such damage is only found
during installation. Damaged equipment may not, under any circumstances, be returned to the manufacturer without prior to written
warning and without the manufacturer's written consent.
Packing Removal
1.2.1
For correct removal of packing, follow the sequence of steps (1 - 5), using the following tools: -crowbar;-screwdriver.
1
1
Manual
PROTECT FROM MOISTURE
Transport
3
2
2
2
2
2
3
2
3
FORK HERE
4
Warehouse
5
3
3
3
2
5
17
Publicité
Chapitres
Table des Matières
