Festo SPC-AIF-INC Instructions D'utilisation page 16

4 Installation
Warning
Interference due to electromagnetic sources is liable to
cause sudden compensatory movements of the axis.
Follow the installation procedure below in order to pre
vent this electromagnetic interference.
Connect the earth connection on the left−hand side of
the housing with low impedance (short cable with
large cross−sectional area) to the earth potential, if the
axis interface is not attached to an earthed machinery
frame.
Connect the earth connection of the drive with low
impedance (short cable with large cross−sectional
area) to the earth potential.
1
Earthing connection
2
Standard cylinder
type DNCI with inte
grated measuring
system
16
1 1
Ì Ì Ì Ì
Ì Ì
Festo SPC−AIF−INC 0406NH English
2