Urban Arrow Tender 1000 Manuel De L'utilisateur page 25

The following non-changeable basic settings are available on the
Intuvia display:
Basic setting Explanation
Power-on hours Indicates the total travel duration with the
e-bike.
Displ. vx.x.x.x Software version of the display.
DU vx.x.x.x Software version of the electrical drive unit.
This menu item is displayed only when the
display is in the holder.
DU SN xxxxxxx/xxx Serial number of the electrical drive unit.
This menu item is displayed only when the
display is in the holder.
DU PN xxxxxxxxxx Part number of the electrical drive unit.
This menu item is displayed only when the
display is in the holder.
Service MM/YYYY This menu item is displayed when the
bike manufacturer has set a fixed service
appointment.
Serv. xx km/mi This menu item is displayed when the
bike manufacturer has set a fixed service
appointment after a certain mileage has
been reached.
Bat. vx.x.x.x Software version of the battery. This menu
item is displayed only when the display is in
the holder.
User manual
Basic setting Explanation
Bat. PN xxxxxxxxxx Software version of the battery. This menu
item is displayed only when the display is in
the holder.
Cha. vx.x.x.x Software version of the charger used to
charge the e-bike battery. This menu item
is displayed only if the charger provides the
software version.
Switching between basic settings and adjusting the basic settings
2
The basic settings can be displayed and changed regardless
of whether the display is inserted in the display holder 33 or
not. Some settings are visible and changeable only when the
display is inserted.
Switching between the basic settings is done as follows:
1. Press the i button 66 on the display or the i button 56 on the
control unit repeatedly until the required setting is displayed.
Adjusting the basic settings is done as follows:
1. Simultaneously press the reset button 71 and the i button
66 on the display until 'Configuration' appears in the text
indicator 68.
2. Press the i button 66 on the display (or the i button 56 on
the control unit in case the display is inserted in the holder)
repeatedly until the required setting is displayed.
EN
23